When the ArcLink option is installed a separate menu appears on the TYPE pull-up menu on the STATUS menu. The ArcLink status menu is similar to the following:
STATUS ArcLink
ArcLink channel: 1
1 Comment: [**************************]
2 CAN status: ONLINE ]
ArcLink status BUS AVAIL
. Motherboard ID: 1
Slot ID: 1
CAN Xmit: 255
CAN Recv: 1371
CAN Error: 0
ArcLink Version
Weld Controller S25386-03
Wire Drive S25424-2
Weld Table Z010104F
ArcLink Object Status READY FAULT
3 Weld Sequencer: 255 0
4 Weld Controller: 255 0
5 Wire Drive: 255 0
6 Gas Controller 0 0
7 Sense Lead Connection 255 0
This menu allows you to set the ArcLink connection online/offline, view the version information of the Power Wave firmware, and check the status of each of the objects on the ArcLink network. If there is a communication error, the word ERROR will appear on the status line. If there are multiple ArcLink channels installed in your system, pressing F2, NEXT_CH will cycle through the available channels.